7.Disconnect bulb wire from its connection in the housing by holding the connector firmly and pulling the wire straight out (Figure I.)
8.To install new bulb, hold the bulb by its metal end and insert into the reflector mounting plate. Align the slots in the bulb base with those in the reflector mounting plate.
9.Tighten the grounding wire screw.
10.Replace wire retainer by pressing prongs together while pressing down.
11.Reconnect the bulb wire to the connector in the housing (Figure J.)
12.To reassemble, set the reflector into the front housing (laying on a flat surface). Insert the rear housing into the front housing until grooves are aligned.
13.Replace the screws removed in step 3. Do not over tighten.
14.Slide the rubber bezel back into place (rounded edge facing front).
Figure I.
Figure J.
| ORTSPOT | |
RASP | wer | |
ULT |
| ndle Po |
| ,000 Ca | |
1,000 |
| |
K |
LOC |
UNLOCK
7