30EXTERNAL CONTROL DEVICE SETUP
ENGLISH
08.Brightness (Command: k h) To adjust screen brightness.
You can also adjust brightness in the PICTURE menu.
Transmission [k][h][ ][Set ID][ ][Data][Cr]
Data Min: 00 ~ Max: 64 (*transmit by Hexadecimal code)
*Refer to Real data mapping.
Acknowledgement [h][ ][Set ID][ ][OK/NG][Data] [x]
09.Color (Command: k i) To adjust screen color.
You can also adjust color in the PICTURE menu. Transmission [k][i][ ][Set ID][ ][Data][Cr]
Data Min: 00 ~ Max: 64 (*transmit by Hexadecimal code)
*Refer to Real data mapping.
Acknowledgement [i][ ][Set ID][ ][OK/NG][Data] [x]
10.Tint (Command: k j) To adjust screen tint.
You can also adjust tint in the PICTURE menu. Transmission [k][j][ ][Set ID][ ][Data][Cr]
Data Red: 00 ~ Green: 64 (*transmit by Hexadecimal code)
*Refer to Real data mapping.
Acknowledgement [ j ][ ][Set ID][ ][OK/NG] [Data][x]
11.Sharpness (Command: k k) To adjust screen sharpness.
You can also adjust sharpness in the PICTURE menu.
Transmission [k][k][ ][Set ID][ ][Data][Cr]
Data Min: 00 ~ Max: 32 (*transmit by Hexadecimal code)
*Refer to Real data mapping.
Acknowledgement [k][ ][Set ID][ ][OK/NG][Data] [x]
12. OSD Select (Command: k l)
To select OSD (On Screen Display) on/off. Transmission [k][l][ ][Set ID][ ][Data][Cr] Data 00: OSD off Data 01: OSD on
Acknowledgement [l][ ][Set ID][ ][OK/NG][Data] [x]
13.Remote Control Lock Mode (Command: k
m)
To lock the remote control and the front panel controls on the set.
Transmission [k][m][ ][Set ID][ ][Data][Cr] Data 00: Lock off Data 01: Lock on
Acknowledgement [m][ ][Set ID][ ][OK/NG] [Data][x]
If you’re not using the remote control and front panel
controls on the Monitor set, use this mode. When main power is on/off, remote control lock is released.
If Key Lock is on in the standby mode, TV will not turn on by POWER button of remote control and on the TV.
14.Balance (Command: k t) To adjust balance.
You can also adjust balance in the AUDIO menu.
Transmission [k][t][ ][Set ID][ ][Data][Cr]
Data Min: 00 ~ Max: 64 (*transmit by Hexadecimal code)
*Refer to Real data mapping. Acknowledgement [t][ ][Set ID][ ][OK/NG][Data][x]
15.3D (Command: x t) (For 3D TV) To change 3D mode for TV. Transmission [x][t][ ][Set ID][ ][Data01] [ ][Data02][ ][Data03][ ][Data04][Cr] Data01
00: 3D On | 01: | 3D Off |
02: 3D to 2D | 03: | 2D to 3D |
Data02 |
|
|
00: Top and Bottom | 01: Side by Side | |
02: Check Board | 03: Frame Sequential | |