Safety Instructions / Operation
Original ancillaries / and accessories
JOnly use accessories and tools that are specified in the operating instructions. The use of tools and accessories other than those recommended in the operating instructions could lead to an increased risk of personal injury for you.
Setting the oscillation speed
You can set the desired oscillation speed as needed with the oscillation speed selector 10 . The required oscillation speed depends on the material being worked and can be determined through practical tests.
Any questions?
JYou may begin the work once you have famil- iarised yourself with the instructions, functions and handling of the appliance. The safest work is possible by heeding all information and instructions of the manufacturer.
Operation
Operation
Take note of the mains voltage! The voltage must agree with the information on the type plate of the appliance (appliances that are designated as 230 V can also be connected to 220 V).
Switching On and Off
Switching on intermittent function:
jPress the ON / OFF switch 1 .
Switching off intermittent function:
jRelease the ON / OFF switch 1 .
Switching on continuous operation :
jPress the ON / OFF switch 1 , hold it pressed and press the locking button 2 .
Switching off continuous operation:
jPress the ON / OFF switch 1 then release it again.
10 GB/IE
Attaching a sanding pad
mWarning! Before performing work on the appliance, always disconnect the power. Note: Before attaching a new sanding pad 9 , remove dust and dirt from the sanding plate 8 .
1.Open the two tensioning levers 7 by pushing them up to clamp in a new sanding pad 9 or when switching the sanding pads 9 for the use with different material.
2.Slide the sanding pad 9 at one end under the clamping bar 6 above the sanding plate 8 and clamp it tightly by pressing the tensioning lever 7 back down.
3.Do the same at the other end. Make certain that the sanding pad 9 rests firmly against the sanding plate 8 . See also Fig. B and C.
4.Important! To ensure that vacuuming of dust through the sanding plate 8 is guaranteed, the holes in the sanding pad 9 and the sanding plate 8 must match up.
Various materials require different grit values. You can read which grit value is best suited for which work in our recommendations under "Tips and tricks".
Vacuuming dust
mWarning! Fire hazard! A risk of fire exists when working with electrical appliances that have a dust collection box 4 or can be attached to a vacuum cleaner via an external suction adapter! Under unfavourable conditions, such as flying sparks, grinding of metal or metal remnants in wood, the wood dust in the dust sack (or in the dust bag of a vacuum cleaner) can ignite. This can