Link mode
You can change the transmission speed to prioritize transmission quality or sound quality.
Preparation
If this system is connected to a Bluetooth® device, disconnect it (> “Disconnecting a device”).
1Press [PLAY MENU] to select “LINK MODE”.
2Press [2, 1] to select “MODE 1” or “MODE 2” and then press [OK].
•MODE 1
Emphasis on connectivity.
•MODE 2
Emphasis on sound quality.
Note:
The default setting is “MODE 2”.
Disconnecting a device
1Press [PLAY MENU] repeatedly to select “DISCONNECT?”.
2Press [2, 1] to select “OK? YES” and then press [OK].
Note:
A device is disconnected when you:
•Select a different source.
•Move the device out of the maximum range.
•Disable the Bluetooth® transmission of the device.
•Switch off the system or the device.
Clock and timers
Setting the clock
This is a
1Press [CLOCK/TIMER] to select “CLOCK”.
2Within 20 seconds, press [3, 4] to set the time.
3Press [OK].
Press [CLOCK/TIMER] to show the clock for a few seconds.
Note:
•Reset the clock regularly to maintain accuracy.
•The clock is reset when there is a power failure or when the AC power supply cord is removed.
Play timer
Except for Bluetooth® source
You can set the timer to come on at a certain time to:
• Wake you up
Preparation
Set the clock.
1Press [CLOCK/TIMER] to select “
PLAY”.
2Within 10 seconds, press [3, 4] to set the start time.
3Press [OK].
4Do steps 2 and 3 again to set the end time.
5Press [3, 4] to select the source you want to play and then press [OK].
To start the timer
1Prepare the audio source.
Prepare the music source you want to listen to (disc, USB, radio or external equipment) and set the volume.
2Press [PLAY 
] to select “
PLAY ON”.
“
PLAY ON” is shown.
To cancel, press [PLAY 
] again.
The system must be switched off for the timer to operate.
To check the settings
Press [CLOCK/TIMER] to select “
PLAY”.
Note:
•The play timer starts at a low volume and increases gradually to the preset level.
•The timer comes on at the set time every day if the timer is on.
ENGLISH
VQT5F35
11