Operating Instructions
Before operating the battery charger, ensure that the charger is assembled and installed as per the installation instructions.
WARNING: DANGER OF INJURY OR DEATH
Before connection, disconnection or handling of Guardian battery charger, be sure AC power supplies are off.
NOTE: Connection to or disconnection from live wiring can also cause damage to internal components.
Terminal Connection Information
Output: | To battery |
| CAUTION: Observe correct polarity |
Input: | AC supply |
| CAUTION: Observe correct voltage as stated on unit. |
Alarm Indication | Over voltage, under voltage and charge fail |
Boost: | Boost initiate – Linking these two connectors will force the charger into a |
| single boost cycle of operation. Once the charger has completed a single |
| boost cycle the charger returns to its normal mode of operation. |
| Stripped wire is introduced just before the clamping unit. |
| The clamp spring is pressed down and wire is introduced into the |
| clamping unit immediately. |
| The clamp spring is released – the conductor is automatically clamped. |
NOTE: All connections, including AC input and DC output are made via spring- clamp connections as outlined above.
Section 75 | |
- 7 - |