Porter-Cable FRP350 instruction manual Maintenance, Clean and Inspect Daily

Page 12

MAINTENANCE

CLEAN AND INSPECT DAILY

Disconnect tool from air supply before cleaning and inspection. Correct all problems before placing the tool back in use.

Wipe tool clean and inspect for wear or damage. Use non-flammable cleaning solutions to wipe exterior of tool only if necessary. DO NOT SOAK tool with cleaning solutions. Such solutions can damage internal parts.

Inspect trigger and safety mechanism to assure system is complete and functional: no loose or missing parts, no binding or sticking parts.

Keep all screws tight. Loose screws can cause personal injury or damage tool.

If tool is used without an in-line oiler: place 5 or 6 drops of Air Tool Oil into the air inlet of the tool at the beginning of each workday.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents HP Framer Table of Contents Safety Guidelines / Definitions Important Safety InstructionsGeneral Safety Rules Page Technical Specifications Noise levelCarton Contents EMPLOYER’S ResponsibilitiesFunctional Description Preparing the ToolPage Using the Tool with Selectable Triggering Options Operating InstructionsMaterial being fastened. Experiment with Clearing a Jammed Fastener Maintenance Clean and Inspect DailyService Troubleshooting GuideService and Repairs Accessories Limited WarrantyCanadian PORTER-CABLE Delta Service Centers
Top Page Image Contents