EMPLOYER’S RESPONSIBILITIES
Employer must enforce compliance with the safety warnings and all other instructions contained in this manual.
Keep this manual available for use by all people assigned to use this tool.
For personal safety and proper operation of this tool, read and understand tool labels and manual. Failure to follow warnings could result in DEATH or SERIOUS INJURY. Read and follow all of these instructions carefully.
FUNCTIONAL DESCRIPTION
Use approved
CARTON CONTENTS
1) | HP FRAMER HIGH PRESSURE® | 3) | Air Tool Oil Bottle |
2) | 3/8" NPT plug with cap | 4) | Instruction Manual |
POWER SOURCE
This tool is designed to operate on clean, dry, compressed air at regulated pressures between 80 and 150 PSI (Pounds per Square Inch)(5.5 to 10.3 BAR). The preferred system would include a filter, a pressure regulator, and an automatic oiler located as close to the tool as possible, within 15 ft/4.6 m is ideal. The tool is equipped with a 3/8" male quick connector.
All compressed air contains moisture and other contaminates that are detrimental to internal components of the tool. An air line filter will remove most of these contaminates and significantly prolong the life of the tool. If an
PREPARING THE TOOL
NOTE: This tool is shipped completely assembled. No assembly time or tools are required.
1.After reading and understanding this entire manual, connect tool to air supply (Fig. 18).
2.Orient a strip of approved fasteners with points down (A) Fig. 19, align, and insert into the magazine “T” slot. Points first.
Do not load fastener strip into magazine backwards.
3.Observe fastener icon (A) Fig. 20. Insert fasteners (B) Fig. 20 with points down (C) Fig. 20. Slide fasteners forward to the front of the magazine. The magazine will hold two full strips of fasteners.
IMPORTANT: Fasteners must point in the same direction as they will be driven.
NOTE: This tool has a mechanical lock out device which restricts the tool from firing when the quantity of nails in the magazine is reduced to four. When attempting to unload the magazine be certain to remove all four nails from the magazine, otherwise one loose nail could jam in the magazine when the tool is reloaded and fired.
7