901891 -
CLEARING A JAMMED FASTENER
1.
WARNING: Disconnect tool from air supply and/or remove battery.
2.Open magazine and remove any remaining fasteners (see Fig. 16).
CAUTION: Remove fasteners from tool before opening the fastener guide plate. Fasteners are under pressure and may shoot out of magazine which could cause injury.
3.Depress the quick release latch (A) Fig. 20 and open the fastener guide plate (B) Fig. 20.
4.Remove the jammed fastener (A) Fig. 21.
5.Depress the quick release latch
(A) Fig. 20, close the fastener guide | A |
plate (B), and release the latch (A). |
|
NOSE CUSHION |
|
This tool is equipped with a rubber | B |
nose cushion (A) Fig. 22, that prevents |
|
marring of finished surfaces by the |
|
metal safety during normal operation. |
|
The nose cushion can be removed |
|
and stored in the rear area of the | Fig. 20 |
magazine (B) Fig. 22, when it is not |
|
| |
required. |
|
WARNING: Disconnect tool from air supply and/or remove battery before removing or reinstalling rubber nose cushion.
A
Fig. 21
•HIGH
•NORMAL
•OFF
•EXT AIR
Fig. 22 B | A |
|
12