PYLE Audio 100 instruction manual Connecting to Power Source, Starting and Stopping the Motor

Page 11

F

B

E

A

C

D

Fig. 3A

Fig. 3B

NOTE: Setting the index line to 1/4" on the ring means the cutting edge of the bit is exposed 1/4" below the base.

CONNECTING TO POWER SOURCE

Before connecting tool to power source ALWAYS MAKE SURE SWITCH IS IN THE “OFF” POSITION. Also check that the power circuit is the same as that shown on specification plate of the router.

STARTING AND STOPPING THE MOTOR

Before starting the router, make sure that the bit is clear of the workpiece and foreign objects. Keep a firm grip on router to resist starting torque.

Start and stop the motor by setting the toggle switch (A) Fig. 4 to the “ON” or “OFF” position.

A

Fig. 4

To avoid personal injury or damage to finished work, always allow the motor to come to a COMPLETE STOP before setting it down.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents
Router Important Safety Instructions Table of ContentsCalifornia Proposition Safety Guidelines DefinitionsGeneral Safety Rules General Safety Rules Clear the Router BIT Area before starting motor Additional Specific Safety RulesSymbol Definition Extension Cord Selection MotorOperation Carton ContentsFunctional Description Attaching the Motor to the Router Base Adjusting Depth of CUTStarting and Stopping the Motor Connecting to Power SourceEdge Guide Using the RouterTemplet Guides TroubleshootingService MaintenanceWarranty AccessoriesPage Canadian PORTER-CABLE Delta Service Centers
Top Page Image Contents