Additional Specific Safety Rules

1.HOLD POWER TOOL BY INSULATED GRIPPING SURFACES WHEN PERFORMING AN OPERATION WHERE THE CUTTING TOOL MAY CONTACT HIDDEN WIRING OR ITS OWN CORD. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator.

2.USE CLAMPS OR OTHER PRACTICAL WAY TO SECURE AND SUPPORT THEWORKPIECE TO A STABLE PLATFORM. Holding the work by hand or against your body is unstable and may lead to loss of control.

3.DISCONNECT TOOL FROM POWER SOURCE before making adjustments or changing bits.

4.TIGHTEN COLLET NUT securely to prevent the bit from slipping.

5.USE A CLAMP or some other device to hold the workpiece rigidly in position. and clear the path of the tool of obstructions.

6.PROVIDE CLEARANCE under workpiece for router bit when through- cutting.

7.CHECK TO SEE THAT THE CORD will not “hang up” during routing operation.

8.CLEAR THE ROUTER BIT AREA before starting motor.

9.MAINTAIN FIRM GRIP on router to resist starting torque.

10.KEEP HANDS CLEAR OF BIT when motor is running to prevent personal injury.

11.KEEP CUTTING PRESSURE CONSTANT. Do not overload motor.

12.LET THE MOTOR COME TO A COMPLETE STOP before putting the tool down.

13.NEVER TOUCH router bits after use. They may be extremely hot.

14.NEVER TIGHTEN COLLET NUT without a bit.

15.DO NOT USE ROUTER BITS with a diameter in excess of 2-1/2" at RPM above 13,000. Router bits up to 3-1/2" in diameter can be used when speed control is set for 13,000 RPM or less.

16.ALWAYS KEEP CHIP SHIELD clean and in place.

17.AVOID “CLIMB-CUTTING”(see “Using The Router” section in this manual). “Climb-cutting” increases the chance for loss of control resulting in possible personal injury.

18.DO NOT HAND-HOLD THE ROUTER IN AN UPSIDE-DOWN OR HORIZONTAL POSITION. The motor can separate from the base if not properly attached according to the instructions.

19. USE OF THIS TOOL CAN GENERATE AND DISBURSE DUST OR OTHER AIRBORNE PARTICLES, INCLUDING WOOD DUST, CRYSTALLINE SILICA DUST AND ASBESTOS DUST. Direct particles away from face and body. Always operate tool in well ventilated area and provide for proper dust removal. Use dust collection system wherever possible. Exposure to the dust may cause serious and permanent respiratory or other injury, including silicosis (a serious lung disease), cancer, and death. Avoid breathing the dust, and avoid prolonged contact with dust. Allowing dust to get into your mouth or eyes, or lay on your skin may promote absorption of harmful material. Always use properly fitting NIOSH/OSHA approved respiratory protection appropriate for the dust exposure, and wash exposed areas with soap and water.

SAVE THESE INSTRUCTIONS!