PYLE Audio PT382 instruction manual Specifications, Assembly, Operation, Accessories Required

	SPECIFICATIONS
Maximum Torque	125 ft./lbs.
Blows Per Minute @ 90 PSI	1800
Maximum Working Pressure	90 PSI
Air Inlet	1/4” NPT
Recommended Hose Size	3/8” I.D.
Air Consumption @ 90 PSI	3.5 SCFM
	ASSEMBLY
Accessories Required

IMPORTANT: Line pressure or hose inside diameter should be increased to compensate for unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8” I.D. and fittings should have 1/4” NPT thread.

OPERATION

Operation

Before each use:

●Drain water from air compressor tank and condensation from air lines. See air compressor’s operators manual.

Disconnect the tool from the air supply before

lubricating or changing sockets

●Lubricate tool, see “Maintenance” section in this manual.

Impact wrench sockets and accessories must be

used with this tool. Do not use hand sockets and accessories.

●Select the required impact socket. This tool has a 3/8" square drive, use 3/8” deep sockets. Use 3/8” extensions only when needed.

Button

Trigger

Air Inlet

Torque

Regulator

●Connect tool to air hose of recommended size. NOTE: The use of a quick connect set makes connecting easier.

IMPORTANT: The use of air filters and air line lubricators is recommended.

To use:

●

●

Turn air compressor on and allow air tank to fill.

Set the air compressor’s regulator to 90 PSI. This tool operates at a maximum 90 PSI pressure.

●Set torque regulator, see chart, to set the desired setting to avoid over tightening.

IMPORTANT: These torque values can vary depending on the size of the air compressor and the cubic feet of air (SCFM) the air compressor delivers.

Line up desired torque # with raised pin

#1 approximately 70-80 ft./lbs. Torque #2 approximately 80-90 ft./lbs. Torque #3 approximately 90-100 ft./lbs. Torque #4 approximately 100-125 ft./lbs. Torque

5- ENG D22727