General safety advice for electrical power tools
b)Do not use an electrical power tool if its switch is defective. An electrical power tool that can no longer be switched on and off is dangerous and must be repaired.
c)Pull the mains plug out of the socket before you make any adjustments to the device, change accessories or when the device is put away. This precaution is intended to prevent you from unintentionally starting the device.
d)When not in use always ensure that electrical power tools are kept out of reach of children. Do not let anyone use the device if he or she is not familiar with it or has not read the instructions and advice. Electrical power tools are dan- gerous when they are used by inexperienced people.
e)Look after the device carefully. Check that moving parts are working prop- erly and move freely. Check for any parts that are broken or damaged enough to detrimentally affect the functioning of the device. Have dam- aged parts repaired before you use the device. Many accidents have their origins in poorly maintained electrical power tools.
f)Keep cutting tools clean and sharp. Carefully maintained cutting tools with sharp cutting edges are less likely to jam and are easier to control.
g)Use the electrical power tool, accesso- ries, inserted tools etc. in accordance with these instructions and advice, and the stipulations drawn up for this particular type of device. In doing this, take into account the working conditions and the task in hand. The use of electrical power tools for purposes other than those intended can lead to dangerous situations.
Safety advice relating specifically to Electric nailer / staplers
DANGER OF INJURY! Never point the device at yourself or at oth-
er people or animals. Ensure that no people or animals are on the other side of the workpiece.
Protect your eyes! Wear protec- tive glasses. This also applies to people who may be helping with the
work by supporting or holding the workpiece. Make sure the device is switched off before you load the magazine. Set the ON / OFF switch to position “0” and pull the mains plug out of the mains socket!
Do not use the device to fix electrical cabling in place.
Secure the workpiece. A workpiece held in a clamp or vice is kept more securely in place than one held by your hand.
Always work with the mains lead leading away from the rear of the device.
DANGER OF INJURY! Use the device with only the staples and nails specified above. En- sure that the staples or nails do not project from the surface of the workpiece or penetrate through to the other side.
DANGER OF INJURY! Keep your fingers and other body parts away from the front plate 7 . Never fire staples or nails through the air. At short range the shot staples or nails could lead to serious injury.
Only soft materials such as wood or textiles should be joined using the device. Otherwise the device could be damaged.
CAUTION! Connect the device to the mains only when it is switched off. Set the ON / OFF switch 2 to position “0”.
WARNING! DANGER OF INJURY! Switch the device on just before you intend to use it. If you are not using the device, switch it off to prevent unintentional firing.
GB/IE/CY 9