Parkside manual Angle grinder PWS 230 A1 Introduction, Proper use, Features and equipment

Introduction

The following pictograms are used in these operating instructions / on the device:

	Read instruction manual!	W	Watts (effective power)
	Observe caution and safety notes!		Safety class II
	Caution – electric shock!		Wear hearing protection, dust
			protection mask, protective glasses
	Danger to life!
			and protective gloves.
	Risk of explosion!		Keep children away from
			electrical power tools!
	Risk of fire!		Check that the device, mains lead
			and plug are in good condition!
V~ Volt (AC)			Dispose packaging and appliance in
			an environmentally-friendly way!
n0	Rated idle running speed

Angle grinder PWS 230 A1

Introduction

Please make sure you familiarise your- self fully with the way the device works

before you use it for the first time and that you understand how to handle electrical pow- er tools correctly. To help you do this please read the accompanying operating instructions. Keep these instructions in a safe place. If you pass the device on to anyone else, please ensure that you also pass on all the documentation.

Proper use

The device is intended for the dry cutting, rough grinding and brushing of metal and stone. Any other use or modification to the device shall be considered as improper use and could give rise to considerable dangers. We will not accept liability for loss or damage arising from improper use. The device is not intended for commercial use.

Note: Slots cut in load-bearing walls must comply with standard DIN 1053 Part 1 or the regulations applicable in your country.

These instructions and advice must be observed. Before you start a task, seek the advice of a com- petent structural engineer, architect, or the relevant site management staff.

Features and equipment

1Hand grip (rotatable)

2 ON / OFF switch

3 Safety lock-out

4 Unlocking button

5 Carbon brushes cover

6 Auxiliary handle

7 Disc guard cover

8 Clamping lever

9 Coded projection

10Adjuster screw

11Spindle lock button

12Threaded hole (3 x) for auxiliary handle

13Clamping nut (see Fig. G)

14Mounting spindle (see Fig. G)

15Mounting flange (see Fig. G)

6GB/IE