21.Should you choose to use the (Z4) bench dogs, drill twelve 5⁄8" (16mm) holes at the shown locations in Figure 10 in the table top.
60"
20"
71⁄2"
25⁄8"
5"
41⁄4"
Figure 10. Optional bench dog drilling locations.
22.Using a standard screwdriver, assemble the right and left drawer sides to the drawer back. Then slide the drawer bottom into the drawer side grooves (Figure 11) until it is fully seated in the back groove.
Figure 11. Drawer assembly.
23.Install the drawer fronts (Figure 12), the (Y1) knobs, and insert the drawers into their respective drawer slides.
Figure 12. Final assembly.
24.Lubricate drawer slides with light grease peri- odically for smooth operation.
Maintenance
To avoid damaging it, do not store the workbench outside, or in an overly damp or extremely dry location.
If you need help with your new item, call our Tech Support at: (570)
Model H7724 (Mfg. since 7/08)