Grizzly G1128 instruction manual Maintenance, GeneralRollers, Drive Gears, Gearbox Lubrication

Page 19

SECTION 7: MAINTENANCE

GeneralRollers

Regular periodic maintenance on your Model G1128/G1129 Power Feeder will ensure its opti- mum performance. Make a habit of inspecting your Power Feeder each time you use it. Check for the following conditions and repair or replace when necessary.

Caution: Always perform any maintenance with the power off and the machine unplugged.

1.Loose mounting bolts.

2.Worn switch.

3.Worn or damaged cords and plugs.

4.Any other condition that could hamper the safe operation of this machine.

Drive Gears

Lubricate drive gears and chains with grease after every 80 hours of operation. Clean and lubri- cate all the machined surfaces with light machine oil.

Each of the three roller wheels is fitted with a grease fitting. Lubricate after every 80 hours of use. The G1129 comes with a grease gun. The G1128 requires purchasing a grease gun from your local hardware store.

Replace rollers when they become worn or dis- figured. Rollers may be ordered through the Grizzly parts department. Contact the appropriate service department.

Clean the wheels when they become dirty. Use a moist brush with light detergent. Do not allow dirty wheels to leave unwanted marks on your work- piece.

Gearbox Lubrication

The internal gearbox oil should be drained and replaced after every 500 hours of operation. A drain plug at the top of the wheel housing pro- vides access for removal of old oil. Remove the motor/wheel apparatus from the pivot joint, remove the plug, tip over and drain. Be careful not to get oil all over the motor. Re-fill to within 12" of the filler plug with 80-90 weight gear oil.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

G1128/G1129 Power Feeders

-17-

Image 19
Contents Power Feeder G1128/G1129 Power Feeders Table Of Contents Manual Before Operating Power Feeder SafetySafety Instructions For Power Tools Additional Safety Instructions For Power Feeders 220V Operation Grounding Circuit RequirementsGeneral Information G1128 Unpacking Piece InventoryG1129 Clean up Site Considerations Mount the motor/wheel assembly to the pivot joint assembly AssemblyG1128/G1129 Power Feeders Roller Placement AdjustmentsTo position the rollers correctly on the G1128 / G1129 Page Table Saw Adjustments G1128 Feed Rates When selecting feed rates, remember these important tipsG1129 Feed Rates Test Run OperationsOperation Gearbox Lubrication MaintenanceGeneralRollers Drive GearsClosure Construction Overall DimensionsSpecifications FeaturesPage G1128 Gear Box 20-5 G1128 Base Type G1128/G1129 Power Feeders Column CAP G1128/G1129 Power Feeders PB08M G1128 Motor57-1 G1129 Gear Box 20-5 20-4 20-3 20-2 20-1 26-2 26-1 G1128/G1129 Power Feeders G1129 Base Type G1128/G1129 Power Feeders PB22M HEX Bolt G1128/G1129 Power Feeders G1129 Motor Symptom Possible Cause Corrective Action TroubleshootingWarranty and Returns