Grizzly G1128 instruction manual Clean up Site Considerations

Page 9

Clean up

 

Site Considerations

 

 

 

 

 

 

The columns and other unpainted parts of the Model G1128/G1129 are coated with a waxy oil that protects them from corrosion during ship- ment. Remove the protective coating with miner- al spirits and paper towels. Do not use gasoline or other petroleum based solvents because of their extremely low flash points. Do not use chlorine- based solvents – if you happen to splash some onto a painted surface, you’ll ruin the finish.

WARNING!

Follow the safety rules listed below when working with solvents:

1.Read and follow all directions and warnings on the solvent label.

2.Work only in a well ventilated area.

3.Do not work near any type of open flame (e.g., pilot lights, kerosene heaters, and so on).

4.DO NOT smoke while working with flamma- ble material.

5.Paper towels from the cleaning process are extremely combustible. Dispose of waste towels so they do not create a fire hazard.

1.Working Clearances: Consider existing and anticipated needs, size of material to be processed through each machine, and space for auxiliary stands, work tables or other machinery when establishing a loca- tion for your power feeder.

2.Lighting and Outlets: Lighting should be bright enough to eliminate shadow and pre- vent eye strain. Electrical circuits should be dedicated or large enough to handle amper- age requirements. Outlets should be located near each machine so power or extension cords are clear of high-traffic areas. Observe local electrical codes for proper installation of new lighting, outlets, or circuits.

 

 

 

 

 

 

 

 

 

 

 

 

G1128/G1129 Power Feeders

-7-

Image 9
Contents Power Feeder G1128/G1129 Power Feeders Table Of Contents Safety Manual Before Operating Power FeederSafety Instructions For Power Tools Additional Safety Instructions For Power Feeders 220V Operation Grounding Circuit RequirementsGeneral Information Unpacking Piece Inventory G1128G1129 Clean up Site Considerations Mount the motor/wheel assembly to the pivot joint assembly AssemblyG1128/G1129 Power Feeders Adjustments Roller PlacementTo position the rollers correctly on the G1128 / G1129 Page Table Saw Adjustments G1128 Feed Rates When selecting feed rates, remember these important tipsG1129 Feed Rates Test Run OperationsOperation GeneralRollers MaintenanceDrive Gears Gearbox LubricationClosure Specifications Overall DimensionsFeatures ConstructionPage G1128 Gear Box 20-5 G1128 Base Type G1128/G1129 Power Feeders Column CAP G1128/G1129 Power Feeders PB08M G1128 Motor57-1 G1129 Gear Box 20-5 20-4 20-3 20-2 20-1 26-2 26-1 G1128/G1129 Power Feeders G1129 Base Type G1128/G1129 Power Feeders PB22M HEX Bolt G1128/G1129 Power Feeders G1129 Motor Symptom Possible Cause Corrective Action TroubleshootingWarranty and Returns