SECTION 5: ADJUSTMENTS
Changing Blades
1.Remove Safety Shield assembly.
2.Remove Table Insert and flip open Chuck Guards. Figure 3.
Figure 3.
3.Mount Blade in Chucks. This can be done with the help of the Chuck Holder, located on the right edge of the table. Figure 4.
4.Mount Chucks between Upper and Lower Arms (Blade teeth should be pointing down toward the table) and close Chuck Guard. Don’t replace the Safety Shield or Table Insert just yet - wait until after you’ve adjust- ed blade tension.
Figure 4.
|
|
|
|
|
|
|
|
|
|
|
|
G1060 22'' Scroll Saw | |||