Grizzly G1060 instruction manual Safety Instructions For Power Tools

Page 4

SECTION 1: SAFETY

WARNING: For Your Own Safety, Read

Instruction Manual Before Operating Scroll Saw

a)Always wear eye protection.

b)Always keep guards in place and in proper operating condition.

c)Do not cut pieces too small to hold by hand.

d)Make sure the blade teeth point downward toward the table.

Safety Instructions For Power Tools

These safety rules cannot cover every situation in a work shop. Consider your conditions when setting up or operating your scroll saw.

1.KEEP GUARDS IN PLACE and in working order.

2.REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that keys and adjusting wrenches are removed from tool before turning on.

3.KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.

4.DON’T USE IN DANGEROUS ENVIRON- MENT. Don’t use power tools in damp or wet locations, or expose them to rain. Keep work area well lighted.

5.KEEP CHILDREN AND VISITORS AWAY. All children and visitors should be kept a safe distance from work area.

6.MAKE WORK SHOP CHILD PROOF with padlocks, master switches, or by removing starter keys.

7.DON’T FORCE TOOL. It will do the job bet- ter and safer at the rate for which it was designed.

8.USE RIGHT TOOL. Don’t force tool or attachment to do a job for which it was not designed.

9.USE PROPER EXTENSION CORD. Make sure your extension cord is in good condi- tion. When using an extension cord, be sure it is rated Hard Service (grade S) or better. Conductor size must be 16 A.W.G. for cords up to 100 feet in length. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. Your exten- sion cord must also contain a ground wire and plug pin. Always repair or replace extension cords if they become damaged. Minimum gage for extension cord:

16 A.W.G. 50ft

16 A.W.G. 100ft

14 A.W.G. 200ft

12 A.W.G. 300ft

-2-

G1060 22'' Scroll Saw

Image 4
Contents Scroll SAW Page Table Of Contents Safety Safety Instructions For Power ToolsAdditional Safety Instructions For Scroll Saws 110V Operation Circuit RequirementsGrounding General Information Unpacking Piece Inventory Clean up Site Considerations Assembly Safety ShieldAdjustments Changing BladesBlade Tension Table Tilt Safety Shield Operations Test Run Straight CutsCurved Cuts Bevel Cuts Inside Cuts GeneralLubrication MaintenanceWorking Table Closure Machine Data 1426 36A G1060 22 Scroll Saw Base Warranty and Returns