7.Check the alignment of the table and both wings with a straightedge. The straightedge should run flat across both wings and the table top. If the straightedge contacts both wings and the table evenly, you are finished with this section. If the straightedge does not contact them evenly, continue to Step 9.
8.If the extension wings tilt up or down at the outside edges, remove the wings and shim them with masking tape as shown in Figure 10.
A)If a wing tilts down, stick layers of mask- ing tape along the bottom edge of the table and retighten.
B)If a wing tilts up, stick layers of masking tape along the top edge of the wing and retighten. Allow the tape to extend above table surface and trim the extended tape with a sharp knife after final assembly.
9.
Masking Tape
Figure 10. Using tape to shim for wing alignment.
Fence & Rails
Your Model G1023S Series comes with a Shop Fox¨ Brand Fence & Rails. Refer to the manual included in the fence box for assembly instruc- tions.
Switch
The switch comes prewired to the motor and can be easily mounted to the rail.
To mount the switch:
1.Line the switch bracket holes up with the holes on the underside of the rail.
2.Secure the switch and bracket to the under- side of the rail using the (2)
3.Disconnect the machine from the power source!
4.Connect the plug on the cord between the switch and motor.
G1023S Series |