Grizzly G1023S instruction manual Service Adjustments, 45˚ & 90˚ Stops

SECTION 8: SERVICE ADJUSTMENTS

!	Disconnect power to the
	machine when perform-
	ing	any	maintenance,
	assembly		or	adjust-
	ments. Failure to do this
	may	result in		serious
	personal injury.

Keep loose clothing rolled up and out of the way of machinery and keep hair pulled back.

Wear safety glasses during the entire adjust- ment process. Failure to comply may result in serious personal injury.

45˚ & 90˚ Stops

1.Set your blade angle at zero as shown on the angle indicator on the front of the saw and raise the blade several inches above the table.

2.Place a machinistÕs square flat on the table and slide it alongside the blade. The square should contact the blade evenly from bottom to top. Make sure that a blade tooth does not obstruct the movement of the square.

3.Adjust the handwheel until the square is flush with the blade. Loosen the tilt indicator arrow, set to zero, and retighten. Loosen and adjust the stop bolt on the left side of the front trunnion to allow a 90¡ stop point. See Figure 37 for details.

4.Turn the blade angle handwheel until the angle indicator points at the desired angle.

5.Tighten the handwheel locking knob.

6.Repeat Steps 1-6for setting the blade to 45¡ and adjust the 45¡ stop bolt on the right side of the front trunnion. Use the 45¡ side of a combo square or a bevel gauge set at 45¡.

45û Stop Bolt

90û Stop Bolt

Figure 37. Geared trunnion.

G1023S Series Heavy-Duty 10'' Table Saw -39-