9.Turn tractor steering wheel to the left as far as it will go.
10.Slide mower out from under right side of tractor.
TO INSTALL MOWER
Follow procedure described in "INSTALL MOWER AND DRIVE BELT" in the As-
sembly section of this manual.
TO LEVEL MOWER
Make sure tires are properly inflated to the PSI shown on tires. If tires are over
or under inflated, it may affect the appear- ance of your lawn and lead you to think the mower is not adjusted properly.
VISUAL SIDE-TO-SIDE ADJUSTMENT
1.With all tires properly inflated and if your lawn appears unevenly cut, de-
termine which side of mower is cutting lower.
NOTE: As desired, you can raise the low side of mower or lower the high side.
2.Go to side of mower you wish to adjust.
3.With a 3/4" or adjustable wrench, turn lift link adjustment nut (A) to the left to lower the mower, or, to the right to raise the mower.
_, CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.
2.Raise mower to its highest position.
3.At both sides of mower, position blade at side and measure the distance
(A) from bottom edge of blade to the
ground. The distance should be the same on both sides.
S
_'.....
4.If adjustment is necessary, see steps 2
and 3 in Visual Adjustment instructions above.
5.Recheck measurements, adjust if nec-
essary until both sides are equal.
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level side-
To obtain the best cutting results, the mower blades should be adjusted so the front tip is 1/8" to 1/2" lower than the rear
tip when the mower is in its highest posi- tion.
_IL CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.
•Raise mower to highest position.
•Position any blade so the tip is pointing straight forward. Measure distance (B)
to the ground at front and rear tip of the blade.
Turn nut right | Turn nut left |
to raise mower | to lower mower |
NOTE: Each full turn of adjustment nut will change mower height about 3/16".
4.Test your adjustment by mowing some uncut grass and visually checking the appearance. Readjust, if necessary, until you are satisfied with the results.
PRECISION SIDE-TO-SIDE
ADJUSTMENT
1.With all tires properly inflated, park tractor on level ground or driveway.
•If front tip of blade is not 1/8" to 1/2" lower than the rear tip, go to the front of tractor.
•With an 11/16" or adjustable wrench, loosen jam nut A several turns to clear adjustment nut B.
•With a 3/4" or adjustable wrench, turn front link adjustment nut (B) clockwise (Itighten) to raise the front of mower, or,
counterclockwise (loosen) to lower the front mower.
25
