Grizzly instruction manual Table Adjustments, Squaring the blade to the table G1052 9 Bandsaw

Page 16

Table Adjustments

The bandsaw table will tilt left 15° and right 45°.

To tilt the table:

1.Loosen the locking handle below the table. Figure 12.

Angle Gauge

Locking Handle

Figure 12. Table adjustment locations.

2.Tilt the table to the desired angle. Refer to the angle gauge on the table bracket. Double-check proper angle adjustment by placing a machinist’s or combination square against the table and blade and adjust until perpendicular. Figure 13.

3.Re-tighten the locking handle.

If the blade is not centered in the table insert, the table can be shifted side to side for adjustment.

1.Loosen the table locking handle.

2.Shift the table to center the blade in the table insert.

3.Secure the table by re-tightening the locking handle. Check table position to ensure that undesirable shifting did not occur during re- tightening.

If the table will not shift adequately, you will need to reposition the blade.

Figure 13. Squaring the blade to the table.

-14-

G1052 9" Bandsaw

Image 16
Contents Bandsaw Page Table Of Contents Safety Safety Instructions For Power ToolsAMP Rating Additional Safety Instructions For Bandsaws Fusing Circuit Requirements110V Operation GroundingIntroduction CommentaryUnpacking Parts InventoryClean Up Site ConsiderationsAssembly Bandsaw UnitBlade Adjustments AdjustmentsTension Co-Planarity Tracking Blade Guides Blade guide assemblies G1052 9 BandsawGuide Bearing Shaft Blade Support Bearing Space Each Side Table Adjustments Squaring the blade to the table G1052 9 BandsawChanging Blades To replace the bladeGuide Post Overview OperationsTest Run Blade Information Ripping Crosscutting Stacked Cuts Cutting CurvesGeneralTable MaintenanceLubrication Closure Machine Data Sheet Parts Diagrams Bearing Guides Table and Fence 100 101 102 104 103 8393 106 105 Parts Lists REF# PART# DescriptionFlat Washer #10 Troubleshooting Symptom Possible Cause Corrective ActionWarranty and Returns Warranty Card Grizzly INDUSTRIAL, INC