Grizzly G7212, G7211 instruction manual Assembly, Fence

Page 12

SECTION 4: ASSEMBLY

Fence

Most of your G7211/G7212 24'' Bandsaw has been assembled at the factory. Only the fence assembly requires installation.

To mount the fence to the bandsaw table:

1.Mount the front rail to the table using two (2) 5/16 - 18 x 21/2'' Cap Screws and the two (2) Spacers provided. See Figure 2.

2.Loosen the fence lock knob and slide the fence onto the rail.

DO NOT attempt any step of assembly, adjustments, or maintenance while your Model G7211/G7212 is running. Ensure that the switch is off, power is disconnected and moving parts have stopped before making adjustments. Failure to comply may result in serious personal injury.

Figure 2. Front rail in place and fence installed.

-10-	G7211/7212 24" Bandsaw

Image 12

Contents Bandsaw Model G7211/G7212Page Table Of Contents Safety Safety Instructions For Power ToolsAMP Rating Additional Safety Instructions For Bandsaws Wiring Diagram Circuit Requirements220V Operation Extension Cords Phase Operation Introduction CommentaryBandsaw Assembly Fence Assembly Miter Gauge Hardware UnpackingParts Inventory Clean Up Site ConsiderationsAssembly FenceAdjustments TrackingTensionTracking Knob Tension WheelAdjusting Knobs Wheel AlignmentRear Support Bearing Bearing Guides Lock Nuts Assembly Upper GuidesLower Guides Blade Guide Lock Nut Blade Guide Adjuster Positive Table StopSee Figure Positive StopOperations Pre-Run CheckBandsaw Blades Changing Blades Changing Speeds Backing off lock boltRipping Stacked Cuts Cutting Curves ResawingMaintenance TableV-BeltsLubricationMiscellaneous Closure Machine Data Sheet G7211 Parts List Locking Handle G7211/G7212 Parts Diagram G7211⁄G7212 Parts Diagram G7211 Switch Wire Diagram Motor Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC BOX BELLINGHAM, WA