Grizzly H4518, H4517 instruction manual AIR Control, Delivered Pressure Air Release

Page 11

AIR CONTROL

Delivered Pressure

 

Air Release

 

 

 

The tank pressure is displayed on the left pressure gauge, and the air to be delivered to the tool is displayed on the right pres- sure gauge, shown in Figure 6.

Figure 6. Pressure gauges.

To control the air delivery to your tool:

1.Adjust the air control knob, shown in Figure 7, to set the PSI that will be delivered to your tool. Turn the knob clockwise to increase the pressure and counter-clockwise to decrease the pressure.

Figure 7. Air control knob.

Note—The air tool that you attach to the air compressor should have a preferred PSI operating level. Set the pressure to be delivered to the tool according to the required level of the tool. Understand the duty cycle of the air compressor.

There are two ways to release air from the compressor tank other than through your regulator and the use of air tools:

—The drain valve —The safety drain valve

To release air by using the drain valve, you simply turn the release nut to allow air to flow out of the tank. The drain valve is shown in Figure 5. The drain valve is also used to drain condensation that builds up in the tank.

The safety valve automatically releases pressure if the tank reaches 130 PSI.

To manually release the air in the tank by using the safety drain valve:

1.Locate the safety drain valve on the tank. The drain valve is shown below in Figure 8.

Figure 8. Safety drain valve.

2.Pull the metal ring on top of the safe- ty valve to bleed pressure from the tank. Note—The ring is preset to release air if the tank exceeds its maximum pressure. DO NOT try to adjust the safety valve pressure set- ting!

Model H4517/H4518 Air Compressors

-9-

Image 11
Contents Model H4517/H4518 Pancake and HOT DOG AIR CompressorsPage Before Operating This Equipment SafetySafety Instructions For Pneumatic Tools Wear Approved Hearing Protection Read this Entire Manual Before Operating the Compressor Additional Safety For Air CompressorsCommentary Introduction and SET UPUnpacking Site Placement Extension Cords Circuit Requirements110V Operation Grounding Duty Cycle Preparing for USETo start the air compressor StartingDelivered Pressure Air Release AIR ControlPressure Regulator Model H4517/H4518 Air Compressors Tank Pressure RegulatorTo connect air tools to your air com- pressor Connecting ToolsEach Use MaintenanceHours of Use After FirstEvery 300 Hours Storage When storing your air compressor, fol- low these guidelinesProblem Cause Action TroubleshootingTurn compressor off, unplug from power Valve Stays Model H4517 Pancake Air Compressor Model H4517 Crankcase Model H4518 Hot Dog Air Compressor Model H4518 PH4518047 Model H4517/H4518 Air Compressors Warranty and Returns Warranty Card Place Stamp Here