Grizzly H4517, H4518 instruction manual Every 300 Hours Storage

Page 16

Every 300 Hours

 

Storage

 

 

 

After every 300 hours or 3 months of regular operation, perform the following maintenance items:

1.Change the compressor oil.

2.Rinse the air filter foam element in water.

3.Check for air leaks and correct as needed.

4.Clean the cylinder head fins for prop- er cooling.

5.Check for loose bolts or fittings.

Like all power tools, there is danger associated with operating this equipment. Accidents are frequently caused by lack of familiarity or fail- ure to pay attention. Use this machine with respect and caution to lessen the possibility of operator injury. If normal safety precautions are overlooked or ignored, serious personal injury many occur.

When storing your air compressor, fol- low these guidelines:

1.Set the compressor switch lever to OFF.

2.Turn the regulator counter-clockwise to set the delivery pressure to zero.

3.Remove the air tool or accessory.

4.Pull the safety drain valve ring to bleed excess pressure from tank. The pressure gauge for the tank should read 15-20 PSI.

5.Drain water from the tank by opening the drain valve on the bottom of the tank.

6.Close the drain valve when all the water has been released.

7.Store air compressor in its normal operating position in a cool protected area.

Water will condense in the air com- pressor tank. Water left in the tank can cause the tank to weaken and corrode, increasing the risk of tank rupture

-14-

Model H4517/H4518 Air Compressors

Image 16
Contents Pancake and HOT DOG AIR Compressors Model H4517/H4518Page Safety Instructions For Pneumatic Tools SafetyBefore Operating This Equipment Wear Approved Hearing Protection Additional Safety For Air Compressors Read this Entire Manual Before Operating the CompressorIntroduction and SET UP CommentaryUnpacking Site Placement 110V Operation Grounding Circuit RequirementsExtension Cords Preparing for USE Duty CycleStarting To start the air compressorAIR Control Delivered Pressure Air ReleaseTank Pressure Regulator Pressure Regulator Model H4517/H4518 Air CompressorsConnecting Tools To connect air tools to your air com- pressorMaintenance Each UseAfter First Hours of UseWhen storing your air compressor, fol- low these guidelines Every 300 Hours StorageTroubleshooting Problem Cause ActionTurn compressor off, unplug from power Valve Stays Model H4517 Pancake Air Compressor Model H4517 Crankcase Model H4518 Hot Dog Air Compressor Model H4518 PH4518047 Model H4517/H4518 Air Compressors Warranty and Returns Warranty Card Place Stamp Here