Grizzly H8208 instruction manual Tire Inflators, Daily Maintenance

Make sure that when the chisel is installed, the retainer spring "U" is holding the chisel as shown in (Figure 4).

Chisel

Retaining

Shoulder

Retainer Spring "U"

Figure 4. Safe chisel position.

To control the chisel hammer rate and the hammering force, turn the knurled thumb knob on the end of the handle. Rotating clockwise reduces the hammer rate and the hammering force.

Tire Inflators

This set contains two tire inflators (Figure 1). Before filling tires, always know what the maximum tire inflation pressure is. NEVER overfill any tire, or it can explode causing severe injury.

The stubby tire inflator (Figure 1) is used for general tire inflation where the valve stem is easily accessible. The long neck version is for filling dual truck tires or other hard to reach valve stems.

Daily Maintenance

Your air tool MUST have 2-6 drops of oil directly dropped into the air fitting before each use. In addition, we recommend using an in-line filter, lubricator, and regulator, as shown in Figure 2. If an inline lubricator is not used, add 2-3 drops of oil into the tool air inlet every 2 hours of continued use.

These procedures should be done after each use:

•Before putting the air tool away, put 2-6 drops of oil into the air supply fit- ting.

Note: For the impact wrench, you must also remove the 4mm plug, put 2-6 drops of oil into the hole, and rein- stall the plug.

•Wipe the tool exterior and sockets, bits, or chisels with a slightly oiled cloth. Your goal is to leave a light film of oil on the tools to prevent rust.

Model H8208 50-Piece Air Tool Set -7-