OPERATING INSTRUCTIONS
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts. If any problems are found, do not use tool until repaired.
Work Piece and Work Area Set Up
1.Designate a work area that is clean and
2.Route the air hose along a safe route to reach the work area without creating a tripping hazard or exposing the air hose to possible damage. The air hose must be long enough to reach the work area with enough extra length to allow free movement while working.
3.Secure loose workpieces using a vise or clamps (not included) to prevent movement while working.
4.There must not be hazardous objects (such as utility lines or foreign objects) nearby that will present a hazard while working.
Full Sequential Safety Trip
Mechanism Definition
This tool has a full sequential safety trip mechanism which is designed to prevent inadvertent firing. The tool should only fire if the Safety Nosepiece is pressed against the workpiece prior to pulling the Trigger. It should only fire again if both Trigger and
Safety Nosepiece are released first, and then both are depressed again. The Tool should not fire if the Safety Nosepiece is not pressed against an object.
Full Sequential Safety Trip
Mechanism Testing Procedure
TO PREVENT SERIOUS INJURY
FROM ACCIDENTAL OPERATION:
Empty the tool before this procedure. Point the tool at a piece of scrap wood when testing.
1.Disconnect tool from the air supply.
2.Empty the Moveable Magazine of fasteners.
3.Check that the Trigger and the Safety move freely, without sticking.
4.Connect the air supply to the tool and set within the Operating Air Pressure indicated on the Specification chart.
5.Test the tool by pressing the Safety against the workpiece without pulling the Trigger. The Tool must not cycle (fire). If it cycles (fires), stop immediately and have it repaired by a qualified service technician.
6.Hold the tool away or off of the workpiece. The Safety should return to its original position. Squeeze the Trigger. The tool must not cycle (fire). If the tool fires, stop immediately and have it repaired by a qualified service technician.
7.Press the Safety against the workpiece and squeeze the Trigger. The tool must cycle (fire) only once. Release the Trigger and squeeze it again. The tool must not cycle (fire). With the Trigger
SKU 68021 | For technical questions, please call | Page 11 |