FUNCTIONAL DESCRIPTION
Functional Description
Specifications
Operating Air | ||
Pressure | ||
| ||
Max. Air Pressure | 120 PSI | |
Air Consumption | .5 CFM @ 90 PSI | |
Air Inlet | 1/4” | |
Fastener Capacity | 3/8” to 2” 18 Gauge Brad Nails | |
Magazine Capacity | 100 Fasteners | |
Safety | Full Sequential Trip Safety |
Components and Controls
Air Deflector
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Unpacking
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at 1‑800‑444‑3353 as soon as
possible.
•This air tool may be shipped with a protective plug covering the air inlet.
Remove this plug before set up.
(3)
Air Inlet
Air Supply
Plug (63)
Trigger
TO PREVENT
EXPLOSION:
Use only clean, dry, regulated, compressed air to power this tool. Do not use oxygen, carbon dioxide, combustible gases, or
(36)
Safety (26)
Latch
(58)
any other bottled gas as a power source for this tool.
1. Connect a regulator valve, an |
off valve and 1/4” NPT air hose (all sold |
separately) to the Quick Coupler. Use |
thread tape for all threaded connections. |
The air hose must be long enough to |
reach the work area with enough extra |
Safety Nosepiece - Also called the workpiece
contact, the Safety Nosepiece helps prevent the tool from firing unless it is pressed against an object.
INITIAL TOOL SET UP/
ASSEMBLY
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
length to allow free movement while |
working. An |
is an important safety device because |
it controls the air supply even if the |
air hose is ruptured. The shutoff |
valve should be a ball valve because |
it can be closed quickly. See pages 8 |
and 9 for Air Tool Setup procedures. |
Note: If an automatic oiler system is not used, add a few drops of Pneumatic Tool Oil into the airline connection before operation. Add a few more drops after each hour of continual use.
SKU 68021 | For technical questions, please call | Page 7 |