Loading/Unloading Nailer

Single Sequential Safety Trip

Mechanism Testing Procedure

TO PREVENT SERIOUS INJURY

FROM ACCIDENTAL OPERATION:

Empty the tool before this procedure. Point the tool at a piece of scrap wood when testing.

1.Disconnect tool from the air supply.

2.Empty the magazine of fasteners.

3.Check that Trigger and Safety Nose- piece move freely, without sticking.

4.Connect the air supply to the tool and set within the Operating Air Pressure indicated on the Specification chart.

5.Test tool by pressing Safety Nose- piece against the workpiece without pulling Trigger. The tool must not cycle (fire). If it cycles (fires), stop immediately and take the tool to a qualified service technician for repair.

6.Hold the tool away, or off of the work- piece. The Safety Nosepiece should return to its original position. Squeeze the Trigger. The tool must not cycle

(fire). If it cycles (fires), stop imme- diately and take the tool to a qualified service technician.

7.Press the Safety Nosepiece against the workpiece and squeeze the Trigger. The tool must cycle (fire) only once. Release the trigger and squeeze it again. The tool must cy- cle (fire) again only once. With the Trigger held, carefully lift the tool and press it against the workpiece again.

The tool must not cycle (fire). If it

fails to act in the manner explained in bold, have it repaired by a qualified service technician.

TO PREVENT

SERIOUS INJURY

FROM ACCIDENTAL

OPERATION, BEFORE

LOADING:

•Wear ANSI-approved safety goggles with side shields. Other people in the work area must also wear ANSI-approved impact safety goggles with side shields.

•Release the trigger.

•Detach the air supply.

•Attempt to fire the Tool into a piece of scrap wood to ensure that it is disconnected and is incapable of firing any fasteners.

1.To load nails, hold Nailer with Safety

(45)pointing downward and push up to release Latch (57) on Magazine

2.Pull back on Magazine slide out Side Cover (56).

3.Insert stick of 3/8” - 2” Brad Nails into front part of Magazine.

4.Please note: Make sure pointed ends of fasteners are resting on bot- tom ledge when loading.

5.Slide the Side Cover forward and into Magazine until Latch catches.

6.To unload nails, follow the above instructions, making sure to first disconnect the air supply before unloading nails.

SKU 66995

For technical questions, please call 1-800-444-3353.

Page 10