![](/images/new-backgrounds/1311327/31132715x1.webp)
Clearing Jams (continued)
5.Inspect the Driver (114) for bends or breakage - see Figure 10. If it is not fully retracted or damaged, do not use the tool until it is repaired by a qualified technician.
6. Lightly oil the Driver (114) and replace Driver Guide Cover C (233). Slide Driver Guide Cover C (233) away from the nose of the Nailer until the shafts of the Cover Hex Bolts (234) fit into the slots in the Cover. Tighten both Cover Hex Bolts (234) securely.
7.Reload the Nailer.
8.Reconnect the Nailer to the air hose.
9.Press the nose of the Nailer against an appropriate piece of scrap wood.
10.Test fire the Nailer several times, checking for proper operation.
Figure 10
Driver (114)
11.Disconnect the Nailer, remove the nails and store Nailer in a location out of children’s reach.
Anytime any maintenance or repairs are done, FIRST:
1.Disconnect the Nailer from the air hose.
2.Empty the Magazine (205) completely.
3.Attempt to fire the Nailer into a piece of scrap wood to ensure that it is disconnected and is incapable of firing any brads.
4.Always leave the Magazine Cover (227) open during maintenance. The Magazine is
Maintenance
ANY MAINTENANCE OR REPAIRS ASIDE FROMTHAT LISTED BELOW SHOULD
ONLY BE PERFORMED BY A QUALIFIED TECHNICIAN.
1.Inspect all of the nuts and screws and make sure they are securely fastened.
2.Periodically lubricate the driving mechanism and magazine with a light oil. Wipe down with a clean cloth.
3.Inspect and clean the Air Filter Regulator and the Air Compressor according to manufacturer’s instructions.
SKU 44923 | For technical questions, please call | Page 8 |