Aligning the degree scale pointer

1.Loosen the table lock knob (17) and position the table so that it is at a right angle to the blade.

2.Place a small square on the table next to the blade to check if the table is at a 90º angle to the blade. If adjustment is needed, change the bevel angle until the table is at approximately 90º to the blade and securely tighten the table lock knob.

3.Loosen the 2 screws holding the degree scale pointer and move the pointer to the 0º position. Securely tighten the screws.

Note. The degree scale is a convenient guide but should not be relied upon for precision. Always make a practice cut in scrap wood to determine if your angle settings are correct.

Turning on and off

1.To turn on the scroll saw lift the on/off switch (1).

2.To turn off the scroll saw push the on/off switch

(1) down.

Adjusting the sawdust blower

Your scroll saw features a sawdust blower (6) to help keep the work area clean for more accurate scroll cuts. For best results always direct air flow from the blower tube at the blade and workpiece.

1. To adjust move tube to the correct position.

Adjusting the LED light

The LED light will illuminate the work area for greater visibility of the cutting line.

1.To turn on the LED light press the LED light button

(3) on the control panel.

2.To adjust the direction of the light move the tube to the most suitable position.

Note. The LED light will not function if the saw is not in the ‘on’ position.