7.Dress correctly. Do not wear loose clothing or jewellery. They can be caught in moving parts. Rubber gloves and
8.Use safety accessories. Safety glasses and earmuffs should always be worn. A face or dust mask is also required if the sanding operation creates dust.
9.Do not abuse the power cord. Never pull the cord to disconnect the tool from the power point. Keep the cord away from heat, oil and sharp edges.
10.Secure the work piece. Use clamps or a vice to hold the work piece. It is safer than using your hand and frees both hands to operate the tool.
11.Do not overreach. Keep your footing secure and balanced at all times.
12.Look after your tools. Keep tools sharp and clean for better and safer performance. Follow the instructions regarding lubrication and accessory changes. Inspect tool cords periodically and, if damaged, have them repaired by an authorised service facility. Inspect extension cords periodically and replace them if damaged. Keep tool handles dry, clean and free from oil and grease.
13.Disconnect idle tools. Switch off the power and disconnect the plug from the power point before servicing, when changing accessories and when the tool is not in use.
14.Remove adjusting keys and wrenches. Check to see that keys and adjusting wrenches are removed from the tool before switching on.
15.Avoid unintentional starting. Always check that the switch is in the OFF position before plugging in the tool to the power supply. Do not carry a plugged in tool with your finger on the switch.
16.Use outdoor rated extension cords. When a tool is used outdoors, use only extension cords that are
intended for outdoor use and are so marked.
17.Stay alert. Watch what you are doing. Use common sense. Do not operate a power tool when you are tired.
18.Check for damaged parts. Before using a tool, check that there are no damaged parts. If a part is slightly damaged, carefully determine if it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, proper mounting and any other conditions that may affect the operation of the tool. A part that is damaged should be properly repaired or replaced by an authorised service facility, unless otherwise indicated in this Instruction Manual. Defective switches must be replaced by an authorised service facility. Do not use a tool if the switch does not turn the tool on and off correctly.
19.Guard against electric shock. Prevent body contact with grounded objects such as water pipes, radiators, cookers and refrigerator enclosures.
20.Use only approved parts. When servicing, use only identical replacement parts. Use an authorised service facility to fit replacement parts.
Additional safety rules for scroll saws
•Do not alter or misuse the tool. These tools are precision built. Any alteration or modification not specified is misuse and may result in dangerous conditions.
•For your own safety, do not operate your scroll saw until it is completely assembled and installed according to the instructions and until you have read and understood all of the instructions.
•Your scroll saw must be bolted securely to a stand or work bench. In addition, if there is any tendency for the scroll saw to tip over or move during certain operations, such as cutting long, heavy boards, bolt your scroll saw stand or workbench to the floor.
5