Troubleshooting
Trouble | Problem | Suggested remedy | |
|
|
| |
Saw will not start | Power cord not plugged in | Ensure that the cord is connected to the power supply | |
|
|
| |
| Power fault, fuse or RCD tripped | Check the power supply | |
|
|
| |
| Cord damaged | Use a qualified electrical repairer to repair or replace | |
|
|
| |
| Burned out switch | Use a qualified electrical repairer to repair or replace | |
|
|
| |
| Faulty motor | Use a qualified electrical repairer to repair or replace the motor | |
|
|
| |
Blade does not reach | Extension cord too long or undersized | Use extension cord heavy enough to carry the current | |
full speed |
|
| |
Tool is overheating | Turn off the tool and let it cool down to room temperature. | ||
| |||
|
| Inspect and clean the ventilation slots | |
|
|
| |
Poor cutting | Accessory blunted | Replace with new circular saw blade | |
|
|
| |
| No water on blade (tile cutting only) | Ensure water cooling on/off lever is in the “on” position | |
|
|
| |
Vibration or abnormal | Loose parts | Check to see that all knobs and levers are securely | |
noise |
| tightened including bevel adjustment lever, depth locking | |
|
| lever and parallel fence locking knob | |
|
|
| |
| Blade vibrating | Ensure that the blade nut is securely tightened | |
|
|
| |
| Moving parts excessively worn | Use a qualified electrical repairer to repair or replace | |
|
|
|
13