Do not have your face close to the safety valve when performing this test as air will discharge from the valve at a high force.
If the safety valve does not operate correctly in any way as described above, turn off the compressor immediately and have the compressor and safety valve checked and tested at an authorised service centre.
DO NOT CONTINUE TO USE THE COMPRESSOR IN ANY WAY IF THE SAFETY VALVE DOES NOT WORK AS ABOVE.
Maintaining the air filter
1.To clean the air filter insert you need to take the air filter (15) apart first. This can be achieved by lifting the air filter housing cover over the protruding tabs on the air filter casing followed by pulling the air filter housing cover towards you.
2.Pull out the air filter and tap it a few times against a surface that is dry and clean to loosen up and remove any dust and build up. Now soak it in warm soapy water, rinse and wring dry.
3.Replace the air filter insert cartridge, then
General inspection
1.Regularly check that all the fixing screws are tight.
2.The supply cord of the tool should be checked frequently for damage. If damaged, have the cordset replaced by an authorised service facility to avoid a hazard.
Cleaning
1.Keep the tool’s air vents unclogged and clean at all times.
2.Remove dust and dirt regularly. Cleaning is best done with a soft brush or a rag.
3.
4.If the body of the compressor needs cleaning, wipe it with a soft damp cloth. A mild detergent can be used but nothing like alcohol, petrol or other cleaning agent.
5.Never use caustic agents to clean plastic parts.
CAUTION. Water must never come into contact with the tool.
Power cord maintenance
Only an authorised service centre should replace the cordset or carry out other repairs. If the cordset is damaged or worn, have it repaired or replaced by an authorised service centre.
15