WARNING. The use of an accessory or attachment, other than those recommended in this Instruction Manual, may present a risk of personal injury.
Additional safety rules for mitre saws
WARNINGS. Before connecting a tool to a power source (mains switch power point receptacle, outlet, etc.) be sure that the voltage supply is the same as that specified on the nameplate of the tool. A power source with a voltage greater than that specified for the tool can result in serious injury to the user, as well as damage to the tool. If in doubt, do not plug in the tool.
Using a power source with a voltage less than the nameplate rating is harmful to the motor.
Your tool is double insulated for additional protection against a possible electrical insulation failure within the tool.
Always remove the plug from the mains socket before making any adjustments or maintenance, including changing the blade.
•When operating the saw, use safety equipment including safety goggles or shield, ear protection, dust mask and protective clothing including safety gloves.
•Ensure that there is adequate general or localised lighting.
•Do not use the saw unless the guards are in place.
•Do not use the saw to cut metal or masonry.
•Do not let anyone under 18 years operate this saw.
•Ensure that the operator is adequately trained in the use, adjustment and operation of the machine.
•Do not use this saw to cut firewood.
•Keep the area free of tripping hazards.
•Report faults in the machine, including guards and saw blades, as soon as they are discovered.
•Ensure that the machine is always fixed to a bench, whenever possible.
•Always stand to one side when operating the saw.
•Never use a cracked or distorted saw blade.
•When cutting round wood, use clamps that prevent the workpiece from turning on both sides of the blade.
•Never use your hands to remove sawdust, chips or waste close by the blade.
•Use only blades as recommended by the manufacturer and which conform to EN
•Do not use blades of High Speed Steel (HSS blades).
•If the table insert is damaged or worn, have it replaced by an authorised service centre.
•Rags, cloths, cord and string and the like should never be left around the work area.
•Avoid cutting nails. Inspect the workpiece and remove all nails and other foreign objects before beginning sawing.
•Support the work properly.
•Refrain from removing any
•Do not attempt to free a jammed blade before first switching off the machine.
•Do not slow or stop a blade with a piece of wood. Let the blade come to rest naturally.
•If you are interrupted when operating the saw, complete the process and switch off before looking up.
•Periodically check that all nuts, bolts and other fixings are properly tightened.
•Do not store materials or equipment above a machine in such a way that they could fall into it.
•Always hold the saw on parts that are insulated. If you accidentally cut into hidden wiring or the saw’s own cable, the metal parts of the saw will become “live”. Switch off at the mains and remove the plug immediately.
•Never saw near combustible liquids or gases.
•Note the direction of rotation of the motor and the blade.
•Do not lock the movable guard in the open position and
7