Accessories

always ensure that it is working properly, freely rotating and returning to fully cover the teeth of the blade.

•Connect the saw to a dust collection devise and ensure that it is operated properly. As the operator of the saw, please make sure that you understand factors that influence exposure to dust, including the type of material to be machined, the importance of local extraction and the proper adjustment of hoods/baffles/shoots of your dust extraction system. We recommend that you always wear a dust mask when operating this saw.

•Wear gloves when handling saw blades and rough materials.

•Saw blades shall be carried in a holder wherever possible.

•Select saw blades in relation to the material being cut.

•Use correctly sharpened saw blades and observe the maximum speed marked on the blade.

•Take additional care when trenching (slotting).

•The mitre saw can be safely carried by the carrying handle but only once it has been removed from the mains power and secured in the locked down position.

•Ensure that the arm is properly secure when bevelling.

•Keep the floor area around the machine level, well maintained and free of loose materials.

•Ensure that you are trained in the use, adjustment and operation of the machine.

•Do not remove any cut-offs from the cutting area until the guard is fully locked in placed and the blade has come to rest.

•When cutting long pieces which extend well over the table width, ensure that the ends are adequately supported at the same height as the saw table top. Supports should be positioned in such a way to ensure that the workpiece does not fall to the ground once the cut has been made. A number of supports at regular intervals may be required if the workpiece is extremely long.

Wear goggles

Wear earmuffs

Wear a breathing mask

The GMC CDB250MS / CDB305MS Double Bevel Compound Mitre Saw is supplied with the following accessories as standard:

•Saw blade (fitted)

•Workpiece clamp

•6mm Hex key

•Side bars x2

•Dust bag

•Instruction manual