Additional Safety Instructions for Nailers/
Staplers
1.Hand injuries: Do not place your hands near the nail/staple point of entry. A nail/staple can deflect and tear through the surface of the workpiece, puncturing your hand or fingers.
2.combustible gases: Never con- nect the nailer/stapler to pressurized oxygen or other combustible gases as an air source. Only use filtered, lubricated, and regulated compressed air.
3.safe handling: Never point the nailer/stapler at others! Do not keep the trigger pulled when loading fas- teners, carrying, or holding tool. Carry the tool only by the handle, never by any other part. Do not carry the tool by the air hose. Disconnect the nailer/ stapler from the air hose when going up and down ladders.
4.MODIFICATIONS: DO NOT modify this tool or bypass the safety nose mechanism.
5.compressed air rating: Do not connect the nailer/stapler to com- pressed air that exceeds 120 PSI.
6.HOSE USAGE: Make sure your air hose is designed for the tool in use, is in good condition, and is long enough to reach your work without stretching. However, an overly long air hose in the work area may be a tripping haz- ard.
7.OPERATING QUESTIONS: If you are not sure about the intended oper- ation, stop using the nailer/stapler. Seek formal training.
8.cleaning: Never use gasoline or other flammable liquids to clean the nailer; vapors in the nailer/stapler will ignite by a spark and cause it to explode.
9.Maintenance: Always disconnect air from the nailer/stapler when ser- vicing or installing nails. During main- tenance, a nailer/stapler connected to air may fire accidentally, causing serious personal injury.
4.check valve: Do not use a check valve or any other fitting that allows air to remain in the tool after it is dis- connected from the air source.
T21347 2" Nailer Kit |