Grizzly H8230, H8231 owner manual Compressed Air System

Compressed Air

System

The Model H8230/H8231 is designed to operate at 70-110 PSI using clean, dry, regulated, compressed air. DO NOT exceed the 120 PSI maximum operating pressure for your model.

An in-line filter/lubricator/regulator unit, depicted in Figure 2, can be installed and should be located as close to the nailer as possible.

This filter/lubricator/regulator unit will protect your tool from damaging water build-up, allow you to adjust and maintain constant air pressure to your tool, and save you the inconvenience of having to manually lubricate your tool every time you use it.

Exceeding the maximum permissible operating pressure may cause the nailer to explode, blowing metal frag- ments in all directions. To protect yourself from serious personal injury, DO NOT allow your air compressor to exceed the recommended pressure when connected to this nailer!

Quick	Quick	Lubricator
Connector	Connector		Regulator

Your

Tool

Quick
Coupler		Quick
	Air Hose
		Coupler

Air

Compressor

Filter

Figure 2. Typical filter/lubricator/regulator installation order.

H8230/H8231 15° Roofing Nailer -5-