Grizzly H8232 owner manual Compressed Air System, Nailer Operating Air Pressure

Compressed Air

System

The Model H8232 is designed to be oper- ated at the following air pressures using clean, dry, regulated, compressed air:

Nailer	Operating Air Pressure
Framing	................................... 80–110 PSI
Finish	60–100 PSI
Palm	70–100 PSI

DO NOT exceed the 120 PSI maximum operating pressure for your nailer.

Before using your new nailers, regulate the air pressure to find the optimum setting within the specified operating range. Start by testing the nailer at a low setting, then increase the air pressure as needed for satisfactory results.

An in-line filter/lubricator/regulator unit can be installed, as depicted in Figure 2.

This filter/lubricator/regulator unit will protect your tool from damaging water build-up, allow you to adjust and maintain constant air pressure to your tool, and save you the inconvenience of having to manually lubricate your tool every time you use it.

Exceeding the maximum permissible operating pressure may damage the nailers and cause them to malfunc- tion. To protect yourself from per- sonal injury, DO NOT allow the air pressure to exceed the recommended pressure for these nailers!

Check the current Grizzly catalog for avail- ability of this unit. If you plan on install- ing a filter/lubricator/regulator unit in your compressed air system, always follow the connection instructions that come with the unit.

Quick	Quick	Lubricator
Connector	Connector		Regulator
Your			Air
Tool			Compressor
Quick
Coupler		Quick
	Air Hose		Filter
		Coupler

Figure 2. Typical filter/lubricator/regulator installation order.

Model H8232 3-Piece Framing/Finish/Palm Nailer Kit -7-