Unloading Nail Strips
To remove unused nails:
1.DISCONNECT NAILER FROM THE AIR SUPPLY!
2.Point the nailer away from you.
3.Pull the pusher back from the nails, then press the pusher lock down as shown in Figure 6.
Pusher Lock
Figure 6. Pulling the pusher back and
releasing the pusher lock.
4.Slide the pusher over the unused nails to the front of the magazine.
5.Slide unused nails back and push the nail stop down as shown in Figure 7.
Nail Stop
Figure 7. Pressing the nail stop down.
6.Slide the unused nails over the nail stop and out the back of the nailer.
Rotating The Exhaust
Cover
The exhaust cover rotates as needed to direct the exhaust away from you.
To rotate the exhaust cover, do these steps:
1.Use the 5MM hex wrench to loosen the exhaust cover cap screw as shown in
Figure 8.
Exhaust
Cap Screw
Figure 8. Loosening the exhaust cap
screw.
2.Rotate the exhaust cover by hand to aim the exhaust port in the desired direction.
3.Tighten the exhaust cover cap screw.
H7943 /H7944 Framing Nailer |