Grizzly H2910 instruction manual Basic Nailer Safety

Page 4

Basic Nailer Safety

In addition to the rules stated in the previ- ous section, and those in the warning boxes throughout this manual, please observe the following safety tips for your new nailer:

1.READ THIS ENTIRE MANUAL BEFORE OPERATING THE NAIL- ER.

2.ALWAYS DISCONNECT AIR FROM THE NAILER whenever servicing or installing nails. During maintenance, a nailer connected to air may fire acci- dentally, causing serious personal injury.

3.DO NOT PLACE HANDS NEAR NAIL POINT OF ENTRY. Nails can deflect and tear through the surface of the workpiece, puncturing your hand or fingers.

4.NEVER CONNECT THE NAILER TO

PRESSURIZED OXYGEN OR OTHER COMBUSTIBLE GASES as a power source. Only use filtered, lubricated, and regulated compressed air.

5.NEVER USE GASOLINE OR OTHER FLAMMABLE LIQUIDS TO CLEAN THE NAILER. Vapors in the tool will ignite by a spark and cause the tool to explode.

6.DO NOT CARRY THE NAILER BY ANY OTHER PART THAN THE HANDLE, and do not carry the nailer by the air hose.

7.DO NOT KEEP THE TRIGGER PULLED ON THE SAFETY YOKE MECHANISM WHEN CARRYING OR HOLDING THE TOOL.

8.DO NOT USE A CHECK VALVE OR ANY OTHER FITTING that allows air to remain in the tool.

Operating the nailer can propel objects into the air, causing immedi- ate eye damage. To protect yourself, always wear American National Standards Institute (ANSI) approved safety glasses or goggles when oper- ating this equipment. In addition, the nailer discharges at 85-90 decibels. To protect your hearing, always wear ANSI approved ear protection when operating this tool.

Never point the nailer at yourself or another person! Always pay attention to the direction the nailer is pointed. Use this tool with respect and caution to lessen the possibility of operator or bystander injury. Ignoring this warn- ing may result in serious personal injury.

-3-

H2910 3-IN-1 WOOD, METAL & CONCRETE NAILER

Image 4
Contents IN-1 WOOD, Metal Concrete Nailer Safety Before Operating This EquipmentAMP Length Rating Basic Nailer Safety Introduction CommentarySafety Yoke Mechanism Compressed Air SystemDepth Adjustment OperationLoading The Nailer Operating The NailerClearing Jammed Nails Disconnect the nailer from the air supplyCleaning The Nailer Oiling The NailerReplacing Pistons/O-Rings 16A 37 39 35A 4354 07 PH2910007 Piston Stopper Troubleshooting Problem Cause ActionWarranty and Returns Warranty Card Place Stamp Here