Grizzly H2910 Operation, Loading The Nailer, Depth Adjustment, Operating The Nailer

Page 7

OPERATION

Loading The Nailer

To load your nailer:

1.Disconnect the air supply from the nailer!

2.Push the magazine latch in the direc- tion shown in Figure 1.

Figure 1. Releasing magazine latch.

5.Push the magazine cover forward until the magazine latch locks in place.

Depth Adjustment

1.Rotate the depth adjustment wheel (shown in Figure 3) clockwise to increase the nail driving depth.

2.Rotate the finger wheel counter-clock- wise to decrease the nail driving depth.

3. Pull back the magazine cover until it

 

stops.

Figure 3. Depth adjustment wheel.

4.Point the nailer down and insert a stick of brad nails into the magazine

as shown in Figure 2. Make sure that

Operating The Nailer

the pointed ends of the nails rest in

If you have not read the safety instruc-

the slot at the bottom of the magazine.

tions in this manual, do not operate the

 

 

nailer.

 

Before you operate your nailer, place one

 

drop of the included oil into the quick con-

 

nect fitting where the nailer connects to the

 

air supply. Fire the EMPTY nailer 3-4 times

 

before beginning, so oil does not come out

 

onto the project during regular operation.

Figure 2. Loading the nailer.

 

H2910 3-IN-1 WOOD, METAL & CONCRETE NAILER

-6-

Image 7
Contents IN-1 WOOD, Metal Concrete Nailer Before Operating This Equipment SafetyAMP Length Rating Basic Nailer Safety Commentary IntroductionCompressed Air System Safety Yoke MechanismOperating The Nailer Depth AdjustmentOperation Loading The NailerDisconnect the nailer from the air supply Clearing Jammed NailsOiling The Nailer Cleaning The NailerReplacing Pistons/O-Rings 16A 37 39 35A 4354 07 PH2910007 Piston Stopper Problem Cause Action TroubleshootingWarranty and Returns Warranty Card Place Stamp Here