Grizzly H6143 Clearing Jammed Nails, To clear a jammed nail from the dis- charge area

Page 12

Clearing Jammed

Nails

A jammed nail must be cleared before using the nailer again.

To clear a jammed nail from the dis- charge area:

1.DISCONNECT NAILER FROM THE AIR SUPPLY!

2.Pull back and latch the magazine pusher.

3.Remove the nail stick from the maga- zine.

4.Open the nailer nose by removing the rubber nose tip, squeezing the nose release mechanism (Figure 7), and opening the nose cover.

Nose Cover

Nose Release

Nose Tip

 

Figure 7. Nose opened to clear a jam.

5.Dislodge the jammed nail with a tool that will fit in the slot on the underside of the nose.

6.Throw the damaged nail away and insert a new nail stick that only contains clean, undamaged nails. DO NOT use dirty or damaged nails!

7.Release the catch lever and let the pusher slide to the front of the maga- zine.

-10-

H6143 16 Ga. Finish Nailer

Image 12
Contents Model H6143 Gauge Finish Nailer Safety Safety Instructions For Pneumatic ToolsBefore Operating This Equipment Wear Approved Hearing Protection Additional Safety Instructions for Nailers H6143 16 Ga. Finish Nailer Introduction ForewordMachine Data Contact InfoSET UP UnpackingInventoryCompressed Air System Safety Nose Mechanism Disconnect Nailer from the AIR SupplyOperations LoadingOperating Adjusting Depth To adjust the depthClearing Jammed Nails To clear a jammed nail from the dis- charge areaReplacing Pistons/O Rings Cleaning & Lubrication CleaningLubricatingH6143 Parts Breakdown H6143 Parts List DescriptionTroubleshooting Symptom Possible Cause SolutionWarranty and Returns Warranty Card Place Stamp Here