Grizzly G1847 instruction manual Loading Brads, To load the nailer

Page 7

Loading Brads

To load the nailer:

1.Disconnect the air hose if connected.

2.Lift the magazine latch that holds the maga- zine in place. Figure 1.

Magazine Latch

Figure 1. Releasing magazine latch.

NOTE

Be sure that brads are in good condition before attempting to load them into the gun. Rusty, corroded, bent, or damaged brads should be discarded. Loading small, partial bands of brads can also jam the gun. Also, be sure that the brads you are using are the correct size and style for the gun.

3.Slide the magazine out and place the brads into the nailer. Your nailer has slots in its magazine to accommodate different size brads. Figure 2.

4.Close the magazine. The latch will snap into place if the brads are seated correctly.

Slots

Figure 2. Inserting brads in magazine.

Do not force the magazine shut after load- ing. If the magazine seems stuck, or if it requires more pressure than normal to slide the magazine into it’s “firing” position, slide it back out and remove the brads. Try slid- ing the magazine while empty. If the maga- zine slides easily, open again, reload, and try to secure it.

If the magazine has difficulty closing when empty, inspect for a loose brad or other for- eign object that may be jammed between the magazine slide and the frame of the gun.

CAUTION: Disconnect the gun from its air source whenever you need to inspect or service the gun. Failure to do so could result in misfire and potential injury to the operator or others in the work area.

-6-

G1847 / G1852 / G 1861 / G3811 Air Nailers/Staplers

Image 7
Contents Model G1847 / G1852 / G1861 / G3811 Nail Guns & StaplersTable Of Contents Safety Instructions For Power Tools SafetySafety Instructions for Nail Guns General Information Operations Unpacking Connecting To AirTo load the nailer Loading BradsTo load the stapler Loading StaplesTo ensure that the best quality air enters your nailer Test Fire Air QualityGeneral Cleaning & Oiling MaintenanceInspect and maintain the following items daily To align the nosepiece JammingAligning Nosepiece To repair a jamTo remove the driver Driver ReplacementTo re-assemble the nailer RingsClosure G1847 PSB15M G1852 PSB23M G1861 Gasket SET G3811 Parts Diagram Driver Guide Parts and Accessories Nailer WeightOperating Air Pressure 65 to 90 P.S.I Fastener Length Troubleshooting Guide Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC