Grizzly G1847 instruction manual Loading Staples, To load the stapler

Loading Staples

To load the stapler:

1.Disconnect the air hose if connected.

2.Press down on the magazine latch that holds the magazine in place. Figure 3.

Magazine Latch

Figure 3. Releasing the magazine.

3.Slide the magazine out and place the staples into the nailer. The staples will seat over the guide in the magazine. Figure 4.

4.Close the magazine. The magazine latch will click into place if the staples are loaded cor- rectly.

Staples

Figure 4. Staple placement.

DO NOT load or service any pneumatic nail- er or stapler without first disconnecting it from its air source. Failure to do so could result in a misfire and possible serious injury to the operator or others in the work area.

NOTE

Be sure that staples are in good condition before attempting to load them into the gun. Rusty, corroded, damaged, or incorrectly- sized staples should not be used. Loading small, partial bands of staples can also jam the gun.

DO NOT operate these pneumatic guns without wearing ANSI-approved goggles or safety glasses. Be sure that you are not wearing loose-fitting clothing or jewelry that could become entangled with the trigger and cause misfires. Serious personal injury could result. Never attempt to disconnect the safety mechanisms on any of these guns. In addition to voiding their warranties, doing so could result in serious injury to the operator or others in the work area.

G1847 / G1852 / G 1861 / G3811 Air Nailers/Staplers -7-