OPERATION
Loading Nailer
To load your nailer:
1.Disconnect the air supply from the nailer!
2.Flip the magazine latch in the direc- tion shown in Figure 1.
Figure 1. Releasing magazine latch.
3.Pull back the magazine cover until it stops.
4.Point the nailer down and insert a stick of nails into the magazine as shown in Figure 2. Make sure the pointed ends of the nails rest in the slot at the bottom of the magazine.
When replacing nails for your Model G6048, follow these guidelines:
Gauge: 15/16
Length:
Capacity: 100 Nails
Single/Bump Fire Mode
The Model G6048 is equipped with a sin- gle/bump fire trigger.
To select single or bump fire operation:
1.Disconnect the air supply from the nailer!
2.Locate the hex nut that secures the safety yoke mechanism to the trigger housing. See Figure 3.
3.To select Single Fire mode, tighten the hex nut completely.
4.To select Bump Fire mode, unthread the hex nut at least two full turns.
Adjustment |
Hex Nut |
Figure 3. Single/bump fire adjustment.
Figure 2. Loading brad nails into nailer.
5.Push the magazine cover forward until the magazine latch locks in place.
G6048 15/16 Gauge Nailer |