Grizzly G6048 instruction manual Operating Nailer

Operating Nailer	Besides damaging your workpiece,
	deflection can cause injury if your free
If you have not read the safety instruc-	hand is securing the workpiece in the
tions in this manual, do not operate the	location that the nail deflects.
nailer.	4. Press the trigger. If the nail drove into
	the wood far enough, continue with
Periodically, place one drop of the included	your intended operations. If the nail
oil into the quick connect fitting where the	either went too far or not far enough,
nailer connects to the air supply. After oil-	then adjust the air pressure. More air
ing, wipe off any excess oil near the nailer	pressure will make the nail go deeper
exhaust to avoid dust build-up.	and less air pressure will decrease
	the nail penetration.
To operate your nailer:

1.Connect the air supply to the quick connect fitting.

2.Test the loaded nailer for proper pen- etration. Hold the nailer perpendicular

to the surface of a piece of clean
scrap wood that is thick enough for
the length of nails you have loaded.
Depress the safety yoke mechanism
on your workpiece.
3. Before pressing the trigger, make	Figure 4. Example of nail deflection.
sure your free hand is positioned out
of the way of a potential path of a nail
in case of deflection. (Deflection is
caused when the nail changes its
path, resulting in the nail puncturing
the surface of the workpiece as
shown in Figure 4.)

G6048 15/16 Gauge Nailer -7-