OPERATION
Loading The Nailer/Stapler
To load your nailer/stapler:
1.Disconnect the air supply from the nailer/stapler!
2.Push the magazine latch in the direc- tion shown in Figure 1.
Figure 1. Releasing magazine latch.
3.Pull back the magazine cover until it stops.
4.Point the nailer/stapler up and insert a stick of nails/staples into the maga- zine as shown in Figure 2. Make sure that the pointed ends of the nails/sta- plers point in the same direction as the Model H2912/H2913 nose and the nails/staples rest in the shallow slot at the bottom of the magazine.
Figure 2. Loading the nailer/stapler.
5.Push the magazine cover forward until the magazine latch locks in place.
Depth Adjustment
1.Rotate the depth adjustment wheel (shown in Figure 3) clockwise to increase the nail/staple driving depth.
2.Rotate the finger wheel
Figure 3. Depth adjustment wheel.
Operating The Nailer/Stapler
If you have not read the safety instruc- tions in this manual, do not operate the nailer/stapler.
Before you operate your nailer/stapler, place one drop of the included oil into the quick connect fitting where the nailer/sta- pler connects to the air supply. Fire the EMPTY nailer/stapler
H2912/H2913 |