Lubrication
To insure maximum performance, install an air set (oiler, reg- ulator, air filter) as close as possible to the tool. Adjust the oiler so that one drop of oil will be provided for every 20 nails.
When an air set is not used, oil the tool with pneumatic tool oil by placing 2 (two) or 3 (three) drops into the air fitting. This should be done before and after use. For proper lubrication, the tool must be fired a couple of times after pneumatic tool oil is introduced.
Nail guide
D1
D2
Gauge
Selecting nails
CAUTION:
•Do not drive hardened steel nails or stainless steel nails into concrete or steel plate. If you do so, the nailer may be adversely affected.
Always check the size of the nail head with the gauge on the nail guide before loading the nailer. Different size nails may be mixed up in the nails you purchase locally.
Do not use nails with a head size larger than D1 or smaller than D2. Nails with a head size larger than D1 cannot be inserted into the nail guide. Nails with a head size smaller than D2 may move into the contact arm and cannot be driven.
11