Figure 3
Regulator
Air Flow
Oiler
Filter
NOTE
Excessive oil will damage
Do not use any type of flammable gases or oxygen as a power source for the tool. Use filtered, lubricated, regulated com- pressed air only. Use of compressed gas instead of compressed air may cause the tool to explode and cause death or serious personal injury.
Do not use a check valve or any other fittings which will allow air to remain in the tool. Serious personal injury or prop- erty damage could occur.
Use a Pressure Regulator on your compressor with an operating pressure of
Always connect the Female Quick Cou- pler to the air hose. Never connect the Female Quick Coupler to the tool.
Never carry the tool by the hose or pull the hose to move the tool or a com- pressor. Keep hoses away from heat, oil, and sharp edges. Replace any damaged, weak or worn hoses.
The air compressor must be able to maintain a minimum of 65 PSI when the tool is being used. An inadequate air supply can cause a loss of power or inconsistent operation.
NOTE
For better performance, install a 3/8"
Quick Connector (1/4" NPT threads) with an inside diameter of .315 (8 mm) on your Tool and a 3/8" Quick Coupler on the air hose. A minimum of 3/8" I.D. air hose with a rated working pressure of 150 PSI or above should be used.
PAGE 8